183 Water Street • New Haven, CT 06511 • Phone (203) 776-0473 • FAX (203) 773-1019 • www.hydrolevel.comMODEL 3200-Plu sTemp Limit / LWCO Controlwith T
10Restore Factory Default SettingsTo restore all features to the factory default settings (see following chart for default settings)1. Turn the LO TEM
11 TEMP ACTIVE Indicates that the Fuel SmartHydroStat control is powered and that the temperaturefunction is active. TEMP HI TEMP Illuminates when t
12MAINTENANCERemove the Electro-Well from the heating system every five years and clean any scale or sediment deposits from all parts thatare exposed
13NOYESNOIs theThermostat (T/TV) Calling for Heat?Is There24 VACBetween B1and B2?NOIs the Indirect (I1-I2) Calling for Heat?NOIs theLow Limit Dial Set
14YESRecheckWiring.ReplaceControl.When there is no call to fire the burner, the voltageshould be 0 volts between B1 and B2. Make sure the burner is w
15ELECTRO-WELLSFuel Smart HydroStatinstalled with Electro-Well™When installed with the Hydrolevel Electro-Well, FuelSmart HydroStat will provide both
1683 Water Street • New Haven, CT 06511 • Phone (203) 776-0473 • FAX (203) 773-1019 • www.hydrolevel.comOUTDOOR SENSOR KITHydrolevel's optional O
2IMMERSION WELLSWhen installed on an Electro-Well™ (sold separately), the LowWater Cut-Off function is automatically activated. Heat transfergrease sh
MOUNTING THE CONTROLSTEP 1 Two mounting positions are available on the back of the control (Fig. 1). Select which of the two positions (2 knockouts)
4WIRINGWARNINGElectrical shock hazard. To prevent electrical shock, death or equipment damage, disconnect power supply before installing or servicing
5WIRING continuedWARNINGElectrical shock hazard. To prevent electrical shock, death or equipment damage, disconnect power supply before installing or
NOTE: Settings can be checked using the TEST/SETTINGS Button. See page 11 for details.Setting the High Limit The high limit is factory set at 190°F. T
7HOW THERMAL TARGETING WORKSSYSTEM START-UPRECORD YOUR SETTINGSThermal Targeting technology analyzes thermostat activity and continually evaluates how
8OPTIONAL FEATURESNOTE: The Program Mode ––is accessed by turning the LO TEMP dial to a position just above OFF.Thermal Pre-PurgeThermal Pre-Purge is
9OPTIONAL FEATURES continuedCirculator Activation OptionsWhen in the default mode, the HydroStat activates the circulator (C1/C2 contacts) on calls to
Comments to this Manuals